Installation Instructions

- 2 -
M965964 Rev. 1.0 (12/18)
2
3
INSTALL VALVE TRIM (STANDARD WALL INSTALLATION)
3
4
6
C
H
OFF
1
Figure 3.
7
5
1
Figure 1.
2
PLASTER
GUARD
Figure 2.
1
UP
UP
INSTALL, TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
Note: Apply sealant or Teon Tape to shower arm.
• Remove PIPE PLUG and CAP (1, 2) from shower pipe
and tub ller pipe.
• Install SHOWER ESCUTCHEON (3) onto SHOWER ARM
(4). Apply sealant or Teon tape to threads on both ends
of SHOWER ARM (4) and thread longer leg of SHOWER
ARM (4) into shower elbow.
• Thread SHOWER HEAD (5) onto SHOWER ARM (4).
Install TUB SPOUT (6). Tighten with HEX WRENCH
supplied.
Important: Do not overtighten Set Screw.
CAUTION
Protect nish on SHOWER HEAD
and TUB SPOUT when installing.
5
1
2
6
3
4
APPLY SEALANT OR
TEFLON TAPE TO THREADS
O-RING
HEX WRENCH
1-3/4"
• Figure 1. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2. Make sure O-RING (6) is secure within
ESCUTCHEON HOLDER (3). Push ESCUTCHEON
HOLDER (3) onto CAP (1) and attach with LONG SCREWS (4).
• Figure 3. Install ESCUTCHEON (7) onto CAP (1) and push
ush against nished wall. ESCUTCHEON (7) will snap t
onto ESCUTCHEON HOLDER (5).