Installation and Operation Manual Wireless Digital Clock/Elapsed Time Indicator with Code Blue ® Part # H004789 Rev.
Electrical Shock Hazard SQA461RSxE Owner's Manual WARNING: Hazardous voltage in electrical equipment can cause severe personal injury or death. Inspection, installation, and preventive maintenance should only be performed on equipment to which power has been turned off, disconnected and electrically isolated so no accidental contact can be made with energized parts. Electrostatic Sensitive Devices CAUTION: This equipment contains electronic devices that are sensitive to static electric charges.
Table of Contents SQA461RSxE Owner's Manual Important Installation and Warranty Information.....................................................................................................4 Specifications.............................................................................................................................................................5 Description....................................................................................................................................
SQA461RSxE Owner's Manual IMPORTANT INSTALLATION AND WARRANTY INFORMATION WARRANTY INFORMATION: American Time (the Manufacturer) provides a limited warranty to the Original Purchaser of this product. The Original Purchaser is the party to whom the Manufacturer issued its Sales Order, generally the Manufacturer’s distributor. In order to preserve this warranty, it is important that only persons who have been properly trained and authorized by the Manufacturer service the product.
SQA461RSxE Owner's Manual Specifications GENERAL Weight: ...............................Digital Clock/Timer ................................ 8.80 lb. ................................ATSTCS Control Station............................ 0.27 lb. External Dimensions:..........Digital Clock/Timer ................................ 6.1"h x 24"w x 3.5"deep ................................ATSTCS Control Station............................ 4.63"h X 4.56"w X 1.
SQA461RSxE Owner's Manual The SQA461RSxE is a six-digit digital multi-function synchronized clock/timer which can be used as an up or down counting elapsed timer with an optional Code Blue trigger. The elapsed timers can be started, stopped, resumed, and reset. Both timer modes have a programmable preset value. When the timer reaches the preset value, a two-second audible alarm sounds from the ATSTCS control panel. The Code Blue up counting elapsed timer will override all other modes of operation if used.
Control Station Switch Functions SQA461RSxE Owner's Manual SET Run/Set Switch Set Position: This position is used to set a preset up or down counting time (Timer). It is also used to reset the Code Blue timer. This position is not used for setting time. The controller will allow you to enter in a 12/24 hour mode and set a time. However, the time will be controlled and updated by the SiteSync IQ system controller. Run Position: This position is used to permit Clock/Timer to operate.
CAUTION: Electric Shock Hazard! Ensure that NO electrical power is present on any wire before installation. u Remove the 6-32 black screw on the top of the clock which secures the back mounting plate. Mount the back plate to a single or double gang box. See Figure 2 on page 9. v Make electrical connections (hot, neutral, ground) to non-switched electrical circuit wiring using UL approved wire nuts. Route field wiring away from sharp projections, corners and internal components.
Control Station Installation SQA461RSxE Owner's Manual u v Pull interconnecting field wires into the double gang box. w Mount the Control Station to the double gang box using the machine screws provided. Connect field wiring interconnecting the ATSTCS Control Station with the Digital Clock/Timer to the appropriate wires of the Control Station. See wiring detail below.
Operation SQA461RSxE Owner's Manual Operation Installation Description Powering Up Before applying power, place the SET/RUN switch to the RUN position and the UP/DOWN/CLOCK switch to the CLOCK position. Apply power to the unit. The displays may rotate during the power on self test and then a version number will appear for a few seconds. Once the receiver inside the clock receives a signal from the SiteSync IQ system controller, the clock will display and begin keeping time.
SQA461RSxE Owner's Manual Operation Up Counter Elapsed Time Operation Set the UP/DOWN/CLOCK switch to the UP position. Press RESET to display 00:00:00. Press the START/STOP switch to begin counting elapsed time. Press the START/STOP switch again to stop and hold the count. Press the START/STOP switch again to resume elapsed time counting. To start over press RESET to display 00:00:00 again. When the timer reaches the preset value, it will sound the audible alarm for 2 seconds and hold the time count.
Code Blue SQA461RSxE Owner's Manual Operation Installation Description Description The Code Blue feature provides an override which forces the clock into a special count up elapsed time mode. No matter which of the three normal functions is being displayed, Code Blue input will cause the unit to begin counting elapsed time from 00:00:00. All other functions of the unit continue to operate in the background during a Code Blue.
SQA461RSxE Owner's Manual Importan Considerations The ATSTCS must be in the RUN mode for Code Blue to override. The Code Blue contact does not have to open before resetting the Digital Clock/Timer back to normal operation, but must be opened before another Code Blue can occur. The transition from no voltage to applied voltage (across the K2+ and K2terminals) initiates a Code Blue.
Operator Maintenance SQA461RSxE Owner's Manual Occasionally the Digital Clock/Timer and the Control Station will need to be cleaned. Dampen a soft, nonabrasive cloth with alcohol or a mild detergent. Do not use abrasives or solvents! Gently wipe the exteriors of the units with the cloth. Battery Maintenance The Digital Clock/Timer uses a single 9vdc Ni-Cad battery rechargeable via an on board charger. This battery retains the time of day and timer counts when AC power is lost.
Appendix SQA461RSxE Owner's Manual Appendix 1 UP/CLOCK/DOWN switch in UP position UP/CLOCK/DOWN switch in DOWN position SET/RUN switch in SET position SET/RUN switch in SET position SET/RUN switch in SET position Clock display 24Hr or 12Hr Clock displays flashing hours digits Clock displays flashing hours digits Push INCREMENT to change Push INCREMENT to change Push ENTER Push ENTER Clock displays flashing minutes digits Clock displays flashing minutes digits Push INCREMENT to change Push