Installation Manual

SOFT & HARD TRI-FOLD TONNEAU
INSTALLATION GUIDE
Wash truck bed.
Place assembled tonneau over cab
end of truck box.
Carefully refold the tonneau
without shifting its position on
the truck bed.
Unfold the tonneau fully and adjust
position over the truck bed for
proper cab/tail alignment.
1 2
3
Pull clamp lever
down to secure
against bed flange
With tailgate down, completely
open the tonneau cover.
Slide rear clamps
out to bed flange
and position under
bottom edge of bed
flange.
6 7
Ensure clamp is positioned under bed
flange. Hand tighten until clamp contacts,
then tighten an additional two turns.
Trim only enough of the bed cap edge or liner wall so clamp
contacts bottom of metal flange.
Do not secure to only lip
of bedliner or wall cap.
Do Not Use Wrench or
Overtighten!
100mm
If your truck has a bed cap or bedliner that covers
the metal bed flange, you will need to remove
enough so that all the clamps make solid contact.
4 5
The tri-fold tonneau comes fully assembled. NOTE any damaged or missing parts?
Parts will be shipped to you directly. Call 877-267-6057, Mon - Fri 8:30 am - 5 pm EST
AMERICAN TONNEAU COMPANY
5400 S. State Road, Ann Arbor, MI 48108
TEL: [phone] WEB: AmericanTonneauCompany.com
PART NO: 66000-30 REV: 05.16 Printed in the USA
PLEASE GO TO:
www.americantonneaucompany.com
FOR WARRANTY REGISTRATION