Instructions / Assembly

1. Use a damp cloth or vacuum to remove dust
and dirt from top of the cabinet.
2. Allow surface to dry.
3. Applya1/4-inchbeadofsiliconealongall
parameteredgesofthecabinet.(seeg.1.1)
g.1.1
TIP:Beforeusingsilicone,makesurethatthevanitytoptsyourcabinet.
If your vanity top does not have proper clearance, do not force it on the cabinet
4. Carefullyremovevanitytopfrombox.
Stand vanity top upright with back edge facing down.
 (seeg1.2)
g1.2
5. Carrythevanitytopverticallytothecabinet.
6. Carefullyplacethebackedgeofthevanitytopapprox.
2 inches or as close to the wall as possible. Lower
the vanity top into place while carefully supporting
the center of the vanity top. As the vanity top is
 lowered,carefullyslidethevanitytopbackuntilitts
tightly against the wall.
 (seeg.1.3)
g.1.3
TIP: If there are any voids between top of cabinet and bottom of vanity top,
insert tapered shims as necessary.
7. Run a thin bead of clear silicone around perimeter
 ofthevanitytoptollanyvisiblevoidsbetweenthe
 cabinetandvanitytop.(seeg1.4)
g.1.4
8. Removeexcesssiliconewithacleancloth.
STOP!
IMPORTANTLIFTINGINSTRUCTIONS:
TWO PEOPLE ARE REQUIRED
TO UNPACK AND CARRY THIS VANITY TOP
PROcEDURE