Operating instructions

Installation instructions
REVERSING THE DOOR
[-51REVERSING THE DOOR HANDLES (CONT.)
5.4 Transfer Freezer Door Handle
5.4.1 Remove the screw
holding the handle
to the top of the
door and the two
screws holding the
hand]e to the bottom
of the doon
5.4.2 Remove the handle.
5.4.3 Remove the screw from the
right top edge of the door
and insert it into the handle
screw hole o,1 the left side.
section 5.2.
5.4.5
Attach the handle to die right
edge of the door
with screws at mp and t)otmm,
using bottom holes vacated by
removal of the door stop
SCreWS.
[_] RE-HANGING THE DOORS
6.1 Re-hang the fresh food door
6.1.1 Lower the fresh food door onto the
bottom hinge pin. Be sure the washer
is in place on the pin.
Hinge__
Bracket
Plastic
Washer
SWING (CONT.)
Igl RE-HANGING THE DOORS (CONT.)
6.1.2
Insert the pin o,ithe center hinge into the socket in the
mp of the doon Place the space*; then the washe*; o,1 the
hinge pin. HingePin
NOTE: The center hinge must
be turned over as shown when
mounted o,1 the left side.
PlasticWasher
andSpacer
6.1.3 Tilt the door toward the cabinet. As the door is brought
into position, slide the hinge under the head of the screw
which earlier had been partly driven into the outermost
hole. Insert the remaining screxx_dlen tighten both screws
securel};
6.2 Re-hang the freezer door
6.2.1 Lower the freezer door _ /
onto the center hinge
pin. Be sure the CenterHing_
washer and spacer
are in place on the pin. _._'-_
and Spacer
6.2.2 Tilt the door toward the cabinet, lifting the top hinge so
the pin fits into the socket o,1 the top of the doon
6.2.3.
Make sure the door is slightly above the top of the
cabinet and the gap between the doors is even across the
front. Tighten the top hinge screws. Do not overtighten
dlese screws tighten them until they are just snug, then
mrn them another one-half turn.
14