Use and Care Manual

Preparation for Assembly
READ ALL INSTRUCTIONS in the Owner’s Manual before you start.
VERIFY PARTS. Remove all parts from the box and arrange on a smooth clean surface. Verify that you have all the parts
listed in the below “Parts List”.
If you have any questions or need help, contact Customer Service at 1-800-251-7558 or go to www.mecocorp.com. Be sure
to have the grill model number listed on the front cover of this Manual. If you need replacement parts, look in the Parts List to
fi nd the exact parts you need. If you need a replacement part under warranty, a proof of purchase will be necessary. You will
be asked to forward your proof of purchase via e-mail, or to fax your proof of purchase to 423-639-2570 and reference your
model number. It is important to register your grill and retain your receipt.
Tools Required for Assembly:
Phillips and/or
Straight Screwdriver
Pliers
3/8” Wrench
Adjustable Wrench
Assembly Instructions
ROTISSERIE LOCK TO HOOD/BOWL ASSEMBLY (All Grills)
Insert a 10-24 x 1/2 inch Bolt (4) through the hole between the hood hinges and the electric heating element.
Attach Rotisserie Lock (5) to the Bowl (FIG A). Thread Acorn Nut (6) onto Bolt until the fl at side of the lock
contacts the inside surface of the Grill. You may need pliers to hold the Acorn Nut. The Rotisserie Lock must
remain in contact with the inside surface of the Grill as it is rotated upward, but should fall freely when released.
To release Refl ector Pan and Heating Element from the vertical Rotisserie position, rotate the Handle Control
clockwise slightly to release the pressure from the Rotisserie Lock. Lift Rotisserie Lock up with left forefi nger and
rotate Handle Control back to horizontal element position. (FIG B)