Use and Care Manual

Axle

Cotter Pin

Wheel

SIDE TABLE ASSEMBLY (9325 - 9329)

(FIG J) Attach a Side Table (26) to either end of the Cart by inserting 10-24 x 1 ¼” Bolt (14) through

the top hole in the Pivot Bracket of the Side Table and then through the hole of the Fixed or Roller Leg.

Attach and tighten with 10-24 Lock Nuts (7). You can leave the Side Tables up or fold them down for

storage. To fold them down, slide the Arm Brackets up within the Pivot Bracket and rotate the Table

downward. (FIG K)

WHEEL ASSEMBLY (9320 - 9325 - 9329)

(FIG G) Insert an Rivet Axle (18) through the center hole on the recessed side of the Wheel. (The op-

posite side that is placed against the Leg Tube has a raised cone shaped center.)

Insert the end of the Axle, that extends through the Wheel, through the hole in the end of the Roller Leg

Tube (12) and fasten in place by inserting the Cotter Pin (20) through the hole in the end of the Axle.

(FIG H)

NOTE: Wheel assembly will not ﬁ t tightly, but will be secure.

Set assembled Frame up on the Wheels and Legs (FIG I).

(FIG G)

(FIG H)

(FIG I)

(FIG J)

(FIG K)