Specifications

System Programming IM166-107
Direct Department Calling Configuration
0 To make a record of the programming configuration, mark the desired requirements in the direct department
calling class of service records chart found at the end of Chapter 4.
0 To make the programming selections, dial the feature code and then dial the configuration code (or press the
programming button where appropriate).
NOTE: A lighted LED next to the programming button for the selection indicates the current configuration.
When a single button provides a togg/e (on/off) action, the lighted LED indicates the active feature.
0 The first step in any programming sequence is to enter the base level. Once in this mode, you can dial the
feature code for any desired configuration. Enter the base level with the following procedure: press ITCM then
dial +K# 7 4 6 +++. The last step is to press the SPKR button to end the programming procedure and return the
system to normal operation.
Codes
2. Dial 2 to assign access codes to depts.
Y OU can program department access codes
‘DEPT. CALLING ”
to be any number between 10 and 7999; 3. Dial 1 - 4 for dept. 1 - 4.
“DEPTX YYYY ’
however, the system will not allow you to 4. Dial new access code.
“DEPTX YYYYZZZZ”
assign the same dialing code as both a
NO=: f&w c&e can be maximum of four digik. If it is less than four digits,
station extension number and a department you must dial leading zeros before dialing the number. The txde must
access code nor will the system allow an not conflict with any sktion extension numbers.
extension number conflict such as 15 and 5. Dial next department number and program the access code.
1500. Further, with system defaulted
extension numbers, the assigned
Dial +R for next access code feature.
department access codes must start at
0058 or larger.
Dial +++ f for configuration mode.
To change setting, repeat procedure and make different selection.
Dial 0 for none.
‘NO DEPARTMENT ”
this, calls received on a line that you have Dial 1 for dept 1.
‘DEPARTMENTi ’ ,
assigned to a department will hunt for any
Dial 2 for dept 2.
“DEPARTMENT2 ”
idle station in that department to ring.
Dial 3 for dept 3.
“DEPARTMENT 3 ’
Dial 4 for dept 4. “DEPARTMENT4 ”
3. Select line ports to be assigned (LED On = Assigned).
Line port 1-14 = Dial 01 - 14 or Press Al - Al4
Line port 15,16 = Dial l&l6 or press Bl, 82
Line port 17-24 = Dial 17 - 24 or press HOLD then press Al - Al
4. Dial +K for next department.
I
Press SPKR to end.
I
4-50