Specifications

Maintenance
IMl66-107
Question
How does one set up a DCD
department?
Answer
The procedure for setting up a DCD
department is as follows:
1. Assign stations to departments.
2. Program call fonvard RNA for each
station.
System Manual Reference
Pages 4-50
3. Assign access codes to departments.
4. Assign fines to departments.
How can a user enable a line port
that was disabled?
He or she cannot do this. The
programmer must reprogram the line as
a CO line in order to enable it again.
This is because line type programming
does not toggle on and off.
Page 4-16
During a programming session,
how does a programmer delete
something that he or she has
programmed into station class of
service?
There is a flashing status LED on
the common equipment cabinet
during the initial installation. How
does an installer clear it?
How can I check to see what
programming is presently on a
station?
Most station programming is a toggle
action. A programmer merely performs
the same procedure that he or she
initially performed to toggle the opposite
choice.
Reset the system by interrupting power
for at least ten seconds. While power is
off, make sure the software cartridge is
inserted properly.
The easiest procedure is to program
with a VDT or a personal computer that
is running an appropriate
communications software program. With
this programming method, the
information is easily displayed and
retrieved. Another method is to install a
DSS/BLF console into the station port
adjacent to the programming station.
The console will use lighted LEDs to
indicate the stations that are
programmed with a particular feature.
When using a console on a port where
a telephone was previously used, be
sure to default the port. Also, in order to
view programming with a console, the
system must be using revision 8A
software or later.
Alternately, you can connect a data
printer to the system and request a
printout of the system programming.
Page 4-22
Page 3-36
Pages 4-4,4-54,4-n
6-4