Full Product Manual

ATABLESQ Bar Table Assembly Instructions

Max Weight Capacity 200 Lb

READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THI.S PRODUCT.

This manual provides important information on proper operation & maintenance. Every effort has been

made to ensure the accuracy of this manual. These instructions are not meant to cover every possible

condition and situation that may occur. We reserve the right to change this product at any time without

prior notice.

IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE,

DO NOT USE THIS PRODUCT!

DO NOT RETURN THIS PRODUCT TO THE RETAILER - CONTACT CUSTOMER SERVICE.

If you experience a problem, have questions or need parts for this product, visit our website

http://www.amerihomebrand.com or call Customer Service at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM

Central Time, or email: info@amerihomebrand.com. A copy of the sales receipt is required.

KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE

REFERENCE.

Base (C)

Tabletop (D)

Handle

Table Plate and Leg (E)

Screw

s (F)

Foot

Cap (B)

Support

Cylinder

(A)

201301

Remove Black Cap

Discard Before Assembly

ATTENTION!

PAGE 1
ATABLESQ Bar Table Assembly Instructions 201301 Max Weight Capacity 200 Lb READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THI.S PRODUCT. This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and situation that may occur. We reserve the right to change this product at any time without prior notice.
PAGE 2
ASSEMBLY INSTRUCTIONS ATTENTION! Remove Black Cap Discard Before Assembly 1. Remove Black Cap and discard before assembly. 2 2. Use a Hex Wrench (G) to attach the Table Plate and Leg (E) to the underside of the Tabletop (D) with the provided Hex Bolts (F). Insert the Support Cylinder (A) into the center of the tabletop. 3 3 Set the foot cap over the hole in the Base. (C) Insert the thicker end of the Support Cylinder into the center hole of the Base, and press down FIRMLY. 4 4.