Instructions / Assembly

Page A11
7/07
TYPICAL GUTTER HANGER DETAILS
*Only 1 hole will line up with bolt Center distance on shank is 1/2". Center distance on circle is 3/8". This allows the gutter to be pitched by lowering the circle on the shank in increments of 1/8". Berger
does not imply fitness of use of our components in conjunction with competitors products. Berger will not warrant any system that incorporates products not manufactured by Berger.
Fascia Mounted Shank Plate -
Steep Roof Pitch or Small Fascia
Board may Need #10 or #30 Shank
*
Extended Roof Line
Circle
#1 Shank
Plate
Nut & Bolt
3/4" Clearance
6
12
Fasteners
Wood
Cornice
Cornice Mounted Shank and Circle -
Roof Pitch of 8/12 or Greater will
Require an Extension Shank*
6
12
Extended Roof Line
Circle
#6 Shank
Nut & Bolt
3/4" Clearance
Fasteners
Lock shank against
dent on circle
Rafter Mounted Shank and Circle
with Square Cut Rafter Tails
*
Extended Roof Line
Circle
#11 Shank
Nut & Bolt
3/4" Clearance
6
12
Lock shank against
dent on circle
Fasteners
Roof Mount Shank and Circle with
Recessed Fascia Board - Roof
Pitch of 6/12 or Greater will
Require an Extension Shank*
Extended Roof Line
Circle
#12 or #25 Shank
(Angle may be carefully bent to
accommodate roof pitch. Shank
should be plumb to ground and
parallel to the wall face. Do not heat.)
Nuts & Bolts
3/4" Clearance
Extension Shank
(Shown in full extension - extension
shank should be positioned as high
up on the roof shank as possible
while keeping the gutter below the
extended roof line.)
6
12
Lock shank against
dent on circle
Fasteners
Fascia Mount Shank and Circle with
Angled Fascia Board - Roof Pitch of
8/12 or Greater will Require an
Extension Shank
*
Extended Roof Line
Circle
#30 Shank
Nut & Bolt
3/4" Clearance
6
12
Fasteners
Angled Fascia
Board
Shank should be perpendicular
to ground and parallel
to building face
1/4" Clearance
Extended Roof Line
Fascia Mounted Shank with 6" Fascia
Board - Roof Pitch of Greater than
12/12 will Require an Extension
Shank - Fascia Board of Less than 6"
will Require Extension Shank
*
Circle
#10 or #30
Shank
Nut & Bolt
Fasteners
12
12
Lock shank against
dent on circle
6" Fascia Board
Lock shank against
dent on circle
Shank should be perpendicular
to ground and parallel
to building face
[phone] • [phone] • Fax [phone]
XIDNEPPA ECNEREFER LACINHCET
®