Installation Guide

Instructions for Wet

Location Surface Mounted

Fixtures

A silicone based caulking must be

used to form a water tight seal

around the back of the fixture

before installing.

Fixture Installation

Make sure that electrical power is off to

the electrical box before proceeding.

Clean hands before touching fixture.

 Mount bracket bar to outlet box and

thread nipple to center of bracket bar.

 Attach white wire of fixture to the white

wire from the outlet box using a properly

sized wire connector.

 Repeat process for the black wires.

 Attach bare ground wire and ground wire

from outlet box to the green grounding

screw on bracket bar.

 Place center hole of fixture over nipple

and fasten with cap.

PAGE 1
Instructions for Wet Location Surface Mounted Fixtures A silicone based caulking must be used to form a water tight seal around the back of the fixture before installing. Fixture Installation Make sure that electrical power is off to the electrical box before proceeding. Clean hands before touching fixture. Mount bracket bar to outlet box and thread nipple to center of bracket bar. Attach white wire of fixture to the white wire from the outlet box using a properly sized wire connector.