Installation Guide

Posion your completed mantel close to its final locaon. Make sure you can access the back of
the mantel as your electric fireplace appliance will be installed from back.
Using a Phillips head screwdriver, remove the screws and the metal mounng center opening.
Next unpack the electric fireplace appliance carefully. Posion the appliance behind the fire-
place with front facing the wood mantel. With the help of an adult assistant, li the appliance
and gently slide it into the opening in the mantel. Make sure the appliance is centered le and
right in the opening. Be careful when placing appliance and adjusng, boom of appliance could
scratch the finish of the base/hearth of your fireplace. Re-aach the mounng brackets with the
Phillips head screwdriver, and supplied screws.
GROUNDING INSTRUCTIONS:
This heater is for use on 120 volts. The cord has
a plug as shown at (A) in figure 2. An adapter as
shown at (C) is available for connecng
three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug extending
from the adapter must be connected to a per-
manent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
NOTE: Adapters are NOT for use in Canada
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
B
C
A
Figure 2
3
ELECTRICAL SPECIFICATIONS
Voltage: 120VAC 60Hz
Was: 1400 Was
REAR VIEW OF FIREPLACE
≥1“
≥1“
≥1.5”
ELECTRIC
FIREPLACE
INSERT
（A）
≥1.5”
≥1“
≥1“
ELECTRIC
FIREPLACE
INSERT
（B）
Tube
You
ameriwoodhome.com
INSTALLATION INSTRUCTION
DO NOT OVER TIGHTEN. With the help of an
assistant, carefully li completed unit and place
it with the front facing out in the final locaon
you have chosen for your fireplace. Make sure
to secure the electrical cord before liing or
moving completed fireplace. When choosing a
final locaon, make sure you will have clear
access to grounded electrical outlet.