Installation Guide

ManualsBrandsAmerock ManualsCabinet HardwareHighland Ridge 8 in (203 mm) Center-to-Center Black Bronze Cabinet Drawer Appliance Pull

• Pencil

• Level

• Ruler

• 3/16in Drill Bit

• Drill

Items Required

Printable Mounting Template for use with 8in(203mm) CTC Appliance Pull

Read all instructions prior to installing.

Questions? Contact Amerock customer service at 800-435-6959.

Amerock is not responsible for incorrect drilling or damage to mounting surface.

Visit Amerock.com to download and print 12in(305mm) and 18in(457mm) CTC Appliance Pull templates.

1a. Print both pages at 100% scale on

letter-sized (8.5in x 11in) paper. Do not

scale to ﬁt.

1b. Once complete, check the 8in

center-to-center (CTC) distance with a

ruler to ensure it measures exactly 8in.

STEP 1: Printing This Template

2a. Once you have printed and

checked this template, decide where

you want to mount your appliance

pull. In the following steps, you will

draw a centerline and tick mark on

the cabinet or drawer surface to

help you align this template and

mark drill holes.

2b. Use a level and pencil to lightly

draw a straight centerline on the

cabinet or drawer surface (refer

to Figure 1 or 2 on Page 2). This

centerline will indicate the orientation

and placement of the appliance pull.

2c. Next, make a tick mark on your

drawn centerline to indicate where

you would like the middle point of

the appliance pull (refer to Figure

1 or 2 on Page 2).

2d. Align the top edge of this template

with your drawn centerline on the

cabinet or drawer, and be sure Template

Centerline is aligned with the tick mark

you drew in Step 2c.

2e. Holding the template in place, tape it

to the cabinet or drawer. Using the 8in

CTC line above as a guide, lightly mark

on drawn centerline the two points

where you will need to drill (refer to

Figure 3 on Page 2).

2f. Before drilling, remove template and

use level to re-check that the drawn

centerline is properly aligned with the

cabinet or drawer. If not, erase all marks

and repeat Steps 2b-2f. You are now

ready to proceed with drilling and

installation.

STEP 2: Using This Template

8in CTC 8in CTC

Template

Centerline

Figure 1

Drawing centerline and tick mark

for vertical mounting

Drawn

centerline

Tick mark to

indicate middle

point of pull

Figure 3

Marking drill holes on drawn centerline

Figure 2

Drawing centerline and tick mark for horizontal mounting

Drawn

centerline

Tick mark to

indicate middle

point of pull

Align Template Centerline

with drawn tick mark

PAGE 1

PAGE 2

Amerock

Summary of content (2 pages)

PAGE 1
Template Centerline 8in CTC 8in CTC Printable Mounting Template for use with 8in(203mm) CTC Appliance Pull Read all instructions prior to installing. Questions? Contact Amerock customer service at 800-435-6959. Amerock is not responsible for incorrect drilling or damage to mounting surface. Visit Amerock.com to download and print 12in(305mm) and 18in(457mm) CTC Appliance Pull templates. Items Required STEP 2: Using This Template • Pencil • Level • Ruler 2a.
PAGE 2
Figure 1 Drawing centerline and tick mark for vertical mounting Figure 2 Drawing centerline and tick mark for horizontal mounting Drawn centerline Drawn centerline Tick mark to indicate middle point of pull Figure 3 Marking drill holes on drawn centerline Tick mark to indicate middle point of pull Align Template Centerline with drawn tick mark Amerock® | 10115 Kincey Ave, Huntersville, NC 28078 | 800-435-6959 | Amerock.