Specification

Page 7 of 7
Ames’
®
Blue Max
®
Tile and Floor
Pro
duct Name (as used on Label and List)
C
olor: Blue
Revision Date:
11-4-2022
GHS Safety Data Sheets (SDS)
SECTION 16 – OTHER INFORMATION
HMIS RATINGS
HEALTH
1
FLAMMABILITY
0
REACTIVITY
0
PERSONAL PROTECTION
B
EUROPEAN PRECAUTIONARY PICTOGRAMS
General:
If spraying or in poorly ventilated area:
PREVIOUS SDS REVISION DATE
05/04/2020
REASON FOR REVISION
N/A
VOLATILE ORGANIC COMPOUNDS (VOC’S)
N/A
LEGEND
N.A. – Not Applicable, N.E. – Not Established, N.D. – Not Determined
ABBREVIATIONS USED
N/A – Information or data not available, NTP – National Toxicological Program, IARC –
International Agency for Research on Cancer, NIOSH – National Institute of Occupational Safety
and Health, PEL – Permissible Exposure Limit (8-hour TWA OSHA), TLV – Threshold Limit
Value (8-Hour TWA ACGIH), STEL – Short Term Exposure Limit (15 min. TWA OSHA), C –
Ceiling Value
NOTICE TO READER
It is recommended that each customer or recipient of this Safety Data Sheet (SDS) study it
carefully and consult resources, as necessary or appropriate, to become aware of and
understand the data contained in this SDS and any hazards associated with the product. This
information is provided in good faith and believed to be accurate as of the effective date herein.
However, no warranty, express or implied, is given, the information presented here applies only
to the product as shipped. The addition of a material can change the composition, hazards and
risks of the product. Regulatory requirements are subject to change and may differ between
various locations and jurisdictions. The customer/buyer/user is responsible to ensure that their
activities comply with all country, federal, state, provincial or local laws. The conditions for use of
the product are not under the control of the manufacturer; the customer/buyer/user is responsible
to determine the conditions necessary for the safe use of this product. Due to the proliferation of
sources for information such as manufacturer specific SDS, the manufacturer cannot be
responsible for the SDS's obtained from any other source.
Note: This information must be included in all SDS that are copied and distributed for this
material.
END OF SAFETY DATA SHEET