Manual

Installation & Maintenance Manualii
Contents
Chapter 1: Introduction/Description 1
1.1 Programmable Features ....................................................................................................... 1
1.2 General Information ............................................................................................................. 1
1.3 Controller Features and Functions ........................................................................................ 2
Chapter 2: Installation 3
2.1 Mechanical Installation ......................................................................................................... 3
2.2 Electrical Installation ............................................................................................................ 4
2.3 Wiring Instructions ............................................................................................................... 4
Chapter 3: Programming 5
3.1 Security Input ...................................................................................................................... 5
3.2 Initialization .......................................................................................................................... 5
3.3 Scale Factor ........................................................................................................................ 5
3.4 Number of Outputs .............................................................................................................. 5
3.5 Selecting Number of Outputs ............................................................................................... 6
3.6 Multiprogram (Available Only on P Option Units) .............................................................. 6
3.7 Setpoint Formula ................................................................................................................. 6
3.8 Setpoints ............................................................................................................................. 8
3.9 Clear an Existing Setpoint .................................................................................................. 10
3.10 Clear All Setpoints ............................................................................................................ 10
3.11 Setpoint Availability ........................................................................................................... 10
3:12 Electronic Offset ............................................................................................................... 11
3.13 Motion Detector ............................................................................................................... 11
3.14 Power-Up in a Position or RPM ....................................................................................... 12
3.15 Decimal Point Programming .............................................................................................. 12
3.16 Enable/Disable Outputs ..................................................................................................... 13
3.17 Linear Speed Offset (Available Only on Option P Units .................................................. 13
3.18 Programming 1995 PLS for Linear Speed ......................................................................... 15
3.19 Minimum Speed Disable ................................................................................................... 15
3.20 Time-Based Outputs (Available Only on Option P Units) ................................................ 16
3.21 Brake Monitor Operational Description ............................................................................ 17
Chapter 4: Expansion Modules 20
Chapter 5: Fault Check 21
5.1 PLS Output Status on Fault Conditions ............................................................................... 22