Manual

BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL G921H
16
Nachdem die Verbindung hergestellt wurde, zeigt die Fernsteuerung „RX BIND successful!“ (Verbindung erfolgreich
hergestellt) an und verlässt die Binde-Funktion.
3. Ziehen Sie nun das Bindekabel vom Empfänger ab.
4. Prüfen Sie nun ob alle Bedienelemente funktionieren. Sollte dies nicht der Fall sein, wiederholen Sie die beschriebenen
Schritte.
RX BIND will be required after the remote control is restored to the factory settings. Please operate it in accordance with the
following steps.
1.
Switch on the remote-control. Press the icon to go to the setting menu. Press RX BIND, the remote-control displays
"Binding to RX...". This means that the remote control is waiting for the receiver signal.
2.
Connect the binding cable to the BIND/VCC interface of the receiver and switch on the electronics.
After the connection is made, the remote control will display "RX BIND successful!" and exits the bind function.
3.
Disconnect the binding cable from the receiver.
4.
Check that all the controls are working. If this is not the case, repeat the above steps for RX BIND again.
Bindekabel
RX BIND Line
BIND/VCC SCHNITTSTELLE
BIND/VCC INTERFACE