Service manual

EBS - MARK II
1-2 Released:01/2013
E-mail: [e-mail]; webside: www.amfreece.com
Phone: [phone]; Fax: [phone]
A - INTRODUCTION
2. SAFETY INSTRUCTIONS
This manual includes four categories of safety instructions:
DANGER!
Overlooking instructions may endanger operator’s life.
WARNING! Overlooking instructions may cause severe injury of the operator or damage
the machine.
CAUTION!
Overlooking instructions may damage the machine or cause injury of the
operator.
NOTE!
Ignoring procedures may cause functional problems with the machine.
2.1. GENERAL SAFETY INSTRUCTIONS
Before plugging the machine into electricity, make sure that all covers are fitted. Do not
put the machine into electricity if any cover is removed.
Remember the position of the STOP button, so that you can use it at any time.
Check that electric cables are not damaged. Bare cable could cause an injury. Repair
damaged covers or replace them with new ones.
Do not touch rotating and moving parts at any circumstances.
Do not put your fingers into the sewing needle area at any circumstances.
Before changing the needle, switch off the main switch.
Always unplug the machine from the electricity before machine maintenance and cleaning.
If you are not going to work on the machine, disconnect the power supply with the main
switch.
Do not modify the machine in any way that could endanger its safety.
Keep in mind, that improper handling or wrong maintenance can make each part of the
machine dangerous. It is very important that whoever works with the machine – operate
it or do the maintenance – is acquainted with information in this brochure and parts
catalogue.
Do not miss out doing regular maintenance in accordance with the operational manual.
If the electricity power supply breaks down, switch off the machine with the main switch.
Do not remove, damage, modify or paint safety labels, but keep them clean. In case they
are not legible or not in place, order a new label and place it onto the original spot.