Service manual

EBS - MARK II
C - CORRECT USAGE
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
1-20
4.2.4. In “Show Stitch” phase, the visible stitch is sewn - you can adjust sewing depth while
the 2nd stitch is sewn (“Show Stitch 2/3”) by icons
on the Stitch Style adjust-
ment screen. Avoid collision with the pucker-pin. This applies only for 1 or 2 show stitch
option
.
4.2.5. Next phase is the neck wrapping phase, which is maintained from the Neck Parameters
screens. Adjust the Y-position of the first wrap using icons
- “Neck Wrap 1/17”
displayed in the Current sewing phase field (for 8 neck wraps as an example); avoid col-
lision with the pucker-pin!
Then proceed to the last wrap (“Neck Wrap 17/17”) and adjust Y-position of the last wrap
using icons
; avoid collision with the button! You can use icons to ad-
just the wrapping width - if the distance from button attaching threads is not enough or
even any thread was not caught by wrapping, extend the width.
4.2.6. Finish the jogging till the last final locking (“End Lock”) stitch.
4.3. ADJUSTMENT OF SHANK BUTTONS
4.3.1. Adjust the desired stitch spacing in fabric by icons
on the Shank Button Pa-
rameters screen.
4.3.2. Machine is in the beginning of Jogging mode and “Begin Lock 1/5” (for 2 initial locking
stitches as an example) is displayed in the Current sewing phase field. First initial locking
stitch is being sewn and position of the stitch depth can be adjusted by icons
in
standard case or
if all show stitches option has been selected on
the Stitch Style adjustment screen.
4.3.3. Button attaching phase starts right after the initial locking stitches and “Button” is
displayed in the Current sewing phase field. In the second stitch of this phase (“Button
2/16” for 4 button attaching stitches as an example) adjust the position of the needle from
shank eye by icons
on the Shank Button Parameters screen. Set this parame-
ter in the way that the needle does not collide with the eye of the shank button - minimum
distance from the eye is 0.2 mm; also pay attention to avoid collision of the needle-bar
with the shank button.
4.3.4. In “Show Stitch” phase, the visible stitch is sewn - you can adjust its sewing depth while
the 2nd stitch is sewn (“Show Stitch 2/3”) by icons
on the Stitch Style Adjust-
ment screen. This applies only for 1 or 2 show stitch option
.