Service manual

EBS - MARK II
1-33
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
D - MACHINE CONTROLS
2.5. NECK PARAMETERS
Press icon on the main screen to enter neck parameters screen. You can set the following
parameters:
a) Use icons
to set neck height within range 0-8 mm for buttons with holes and 0-4 mm for
shank buttons. This range can vary according to setting of other parameters.
b) Use icons
to set the number of neck wraps within range 0-30 wraps. When 0 wraps is
set wrapping is not performed.
c) Use icons
to set the position of the wrap closest to the fabric within range 0-3 mm.
d) Use icons to set the position of the wrap closest to the button within range 0-2 mm.
For some combinations of setting of parameters , , and wrapping cannot be performed
due to a possible mechanical collision - this fact is depicted by icon in field and icon
on the main screen.
Press icon
to shift to the second neck parameters screen. You can set the following
parameter:
1. Use icons
to adjust the neck wrapping width. Thinner wraps ensure tighter wrapping,
but pay attention to maintain enough width so that all the button attaching threads are
wrapped.
2. Use icons
to shift the neck wrapping stitches together with the final locking stitch left -
right.
3. For shank buttons only, you can select between:
a) 0-shape wrapping or
b) 8-shape wrapping (additional needle pass through the middle of the neck).
Icons in section
only appear if password level II is submitted (refer to chapter E 1.2.1.).