Service manual

EBS - MARK II
1-62
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
E - STANDARD MACHINE
9. ADJUSTING THE X PUCKER-PIN POSITION
9.1. Move the needle in the position where it is in the level of the pucker-pin . Adjust the
centre of the pucker-pin in X axis to be in one line with the needle , use the screws
(see the figure).
9.2. Check the Y bedplate position (see chapter E 7).
10. ADJUSTING THE CHUCK HEIGHT
Press the icon
4x, in this way move the chuck into its lowest position (- 4 mm). Adjust
the vertical distance between the chuck and the pucker-pin to approx. 0.1 mm.