Service manual

EBS - MARK II
1-68
F - MAINTENANCE
Released:01/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
1.6. Cleaning the fan:
Loosen the screws on the control
cabinet, use a cross screwdriver. Loosen
4 screws
on the fan grid .
ATTENTION! When loosening the last
screw hold the fan with the grid
inside
the cabinet to avoid its fall into the control
cabinet. Put the screwdriver into the
aperture on the grid
, press it through
the cleaning insert and then push out
the plastic cover of the grid . Take out
the cleaning grid. Shake or draw out the
insert, in case of larger dirt wash in a
detergent. Carry out similar maintenance
also on the back grid
.
1.7. Maintenance of the air regulator
It includes the check of the condensate and the possible replacement
of the filtering patron
. The level of the condensate inside the
sludge pit should not reach the level above 10mm under the level
of the filtrating patron . The lower nut collar signalizes this
height. Loosen the emptying screw to drain the condensate and
then tighten the screw again.
If the air flow worsens replace the filtrating patron
after you have
shut off the air. Screw out the sludge pit anticlockwise and vent.
Unscrew the nut , this releases the filtrating patron , replace it
with a new one and then mount the device in the reverse order.
1.8. Visually check the mechanisms, mainly in the area of the sewing. No threads and fabric
can be left in this area.
1.9. Put the covers in their operating position and check the machine operation according to
section C.