Service manual

e-mail: [e-mail]; [e-mail] ; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
Revised 09/2004
S-101
1-15
TO ADJUST PLAY IN SPLIT COLLAR
YOKE
This yoke n must be adjusted to work smoothly
but without excessibe play. Part o is a nut -
loosen screw p and screw up nut o to suit.
TO LINE UP AND ADJUST THE CUTTING LEVER
The cutting lever is suspended upon two
adjustable studs q. Adjust these studs for
centralization of cutting lever.
To adjust cutting messure, turn nuts u
inward for more pressure or outward
for less.
Important!
Release cutting pressure completely
before installing a new cutting steel.
- Cutting after -
same instructions apply to cut
before machines using this
cutting arrangement.
When indentation of knife in cutting steel has become too deep,
the face should be filed until the impressions barely seen. Follow
up by adjusting the cutting pressure to cut.
When replacing with new block. Level the cutting surface
with a file until impression of cutter is distinct throughout its
length. (on both cut after and cut before machines).
Cutter may be aligned as to center and position of eye.
Loosen screw r and adjust knife forward or backward for
correct eye position
For centering adjust cutter in either direction with screws t,
for additional adjustment loosen three screws s and move
block in the direction desired.
o
n
q
u
p
q
r
s
t
3 screws
MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE