Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Released 01/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-6
6. SAFETY INSTRUCTIONS FOR OPERATORS AND SERVICEMEN
A - INTRODUCTION
Screw - top links: Yellow marks — 1. Loosing and following disassembly of this link causes
distinctive intervention to the mechanism adjustment, was
done when assembled and sewed off at the that factory.
2. After such an intervention to the mechanism, new
adjustment of set mechanism needs to be done and complete
check of whole machine adjustment as well.
Blue marks — Screws and nuts secured against loosing with glue
„LOCTITE“.
Lubrication locations: Red marks — CAUTION:
Lubrication regime adherance is necessary
for protection of the reliable long-term machine operation.
When positioning the machine onto its operational place, we recommend keeping the minimal distance of
the machine as in the drawing. Follow the instructions below. Do not start the machine unless you have
carefully read the operator’s manual.
5. COLOURED MARKING