Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Released 01/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-12
B - MACHINE INSTALLATION
5. ADJUSTMENT OF LEFT DRIVE BELT
To get access to the belt tilt the rare cover
ÊÊ
Ê
Ê
Ê. Loose the nut
ËË
ËË
Ë and adjust the gear shaft
ÌÌ
ÌÌ
Ì so that
the motor drive belt Í is tensed. Tighten the gear shaft
ÌÌ
ÌÌ
Ì. By loosing the screws
ÎÎ
ÎÎ
Î adjust the
tension pulley
ÏÏ
ÏÏ
Ï so that, the movement of the front part of the pulley
ÐÐ
ÐÐ
Ð is13 mm (1/2”) when pushing
on it, as shown in the picture below. Tighten the tension pulley screws
ÎÎ
ÎÎ
Î. Place the cover
ÊÊ
ÊÊ
Ê back
onto the machine.
13 mm
10 N
1
2
3
4
65
7