Service manual

ManualsBrandsAMF ManualsBusiness equipmentS-105

Table Of Contents

MODEL S 105

Revised 11/2010

E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phone: +420 582 309 286; Fax: +420 582 360 606

S-105

1-26

2.1 Adjustment is done out of sewing process in the home position of the machine, it means during the time

when the stopping mechanism b

locks the movement of sewing shaft. It is impossible to turn the jand

wheel

ÊÊ

Ê. The play of the roll in this position is 0,1-0,2mm above the draw bar

ÌÌ

Ì. Stopping lever

ÍÍ

secures the roll stud

ÎÎ

Î. Loosen the nut

ÏÏ

Ï, set up gap between the roll

ÌÌ

Ìand the draw bar

ËË

Ë by the

screw

ÐÐ

Ð. Then set up the stop to the roll stud having the play min 0,1mm.

2.2. Spring adjustment on the stopping lever

- picture II. - the

nut is flat to the screw.

2.3. Turn the left wheel until the stop is released from the

right stopping wheel. Once the stop is released, stop the

turning.

2.4. Adjust the clearance 0,1 - 0,2 mm between the dogs by

loosing the screw and turning the wheel as per the

needs. Once the adjustment is done, tighten the screw .

2.5. By turning the wheel you get to the place where the roll

achieves the top position 3. At this moment, release the lever

with the nut and adjust the clearance between the arm

and lever to 0,1 - 0,2 mm. At the end of cycle the

clearance between the dogs should be approx. 0,25 mm or

more. If not, loose the screw in the slot on left side of the

machine and adjust it as per the needs. Test the machine cycle.

D - MACHINE ADJUSTMENT

2. STOPPING MECHANISM

ÊÊ

ÍÍ

ÎÎ

ÎÑ

0,1 mm

ËË

ÌÌ

ÏÏ

ÐÐ

ÊÊ