Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Revised 11/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
S-105
1-38
D - MACHINE ADJUSTMENT
The starting point for the adjustment of the cutting mechanism is the needle mechanism and sewing
mechanism. The method of adjustment depends on the placement of the knife; either into the cutting lever
or into the cutting block. Cutting lever
Ê
Ê
Ê Ê
Ê is fitted onto the shaft
Ë Ë
Ë Ë
Ë with a screw
ÌÌ
ÌÌ
Ì. The axial play is
adjusted with stops
secured with screws . The standard cutting is set up with the knife being fitted in
the cutting block
Í
Í
Í Í
Í and cutting steel in the cutting lever
ÊÊ
ÊÊ
Ê.
12. CUTTING MECHANISM ADJUSTMENT
12.1. Adjustment of the knife fitted in the cutting block
Í Í
Í Í
Í change the position in X axis once you loosen
the screws
Î Î
Î Î
Î Carefully turn the knife to the left or to the right as needed. Tighten the screws again.
12.2. Stopps in the cutting block
Í Í
Í Í
Í and in the cutting lever
ÌÌ
Ì
Ì
Ì. Loosen the screws
Ï Ï
Ï Ï
Ï and
ÐÐ
ÐÐ
Ð. Adjust the
distance 49,5 mm from the top of the cut workpiece, it is 53,5 mm from the nose of the stops.
Ê
Ë
ÌÐ
Í
ÎÎ
ÎÎ
Î
ÏÏ
ÏÏ
Ï
53,5
mm
49,5-0,3 mm