Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Revised 11/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
S-105
1-45
E - MAINTENANCE
3.4 Remove the clamp plates as stated in section E2 ad) 2 and lubricate the drawbar case
Ð
Ð
Ð Ð
Ð and
ÑÑ
ÑÑ
Ñ,
spreader fasteners
Ò Ò
Ò Ò
Ò and
ÓÓ
ÓÓ
Ó, looper spreader stud
, drive drawbar and 1-2 drops of oil onto the
areas mar
ket in the drawing. (marked in red color on the machine). To get better access to the drive
drawbar, tilt the machine head after opening the back cover.
3.5 Check the machine for further lubrication. Pour 1-2 drops into each place marked with red color. Pay
y
our attention especially for sewing cam, feeding mechanism, side needle bite, drive shaft, cutting
lever case and other moving parts.
3.6 Make at least 10 buttonholes on a scrap piece of material after lubrication to eliminate the possibility of
making oil stains on a workpiece; wipe off visible remains of oil.
3.7 Put all removed parts back onto the machine, secure the clamping plates.
ÐÐ
Ð
Ð
Ð
ÑÑ
ÑÑ
Ñ
ÓÓ
ÓÓ
Ó
ÒÒ
Ò
Ò
Ò