Service manual

2-4
S-105
Released 01/2010
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
TROUBLESHOOTING
Damaged or weak
starting lever spring
Switching start lever
Incorrect adjusting roller setting
Machine fails to stop,
but repeates the cycle
Replace the spring 01.5020.0.000
or increase the pressure
a) Increase the spring pressure
b) Replace the spring
01.5019.0.000
Correctly adjust the roller (CA/CB)
Cutting lever fails to
return
Faulty extension spring
Stagnation on shaft
Replace 01.5006.0.001
a) adjust the axial play
b) lubricate
Machine fails to reach
the end position
Breaking belt tension too tight
Fast feed pulley stick
Damaged carrier dog
Excessive cutting pressure
Correctly adjust the pressure
Make pulley motion loose
Replace 17.0033.5.113
Correctly decrease
the cutting pressure
Uneven clamp feet
pressure
T
ighten and adjust the screw
a) Replace
b) Tighten the screws
Rocker lever bearing screw loose
Drive member loose or damaged
Machine fails to
release material
Correctly adjust the roller (CA
/CB)
Re-adjust clamp
Incorrect adjusting roller setting
Clamp disengagement
incorrectly adjusted
Correctly adjust the roller (CA/CB)
T
ighten the carrier dog
Correctly adjust
the pulley collar
Incorrect adjusting roller setting
Loose carrier dog
Pulley collar incorrectly set for
high speed table travel
Knocking noise at the
machine start
SYMPTOM
POSSIBLE CAUSE POSSIBLE SOLUTION
SERVICE
SECTION
Machine fails to cut
material
Replace
Repair or replace
a) Increase the cutting
pressure
b) Replace the tracing finger
17.0062.5.149
Replace 11.1068.0.000
Tighten the screws
Damaged knife
Damaged cutting steel
Incorrect cutting pressure
Damaged cutting lever
Loose machine frame screws
D - 13
D - 14
D - 14
D - 14
D - 14
D - 14
D - 13
D - 13
Machine fails to clamp
material or release the
material too soon
Correctly adjust the
mechanism
Incorrect clamps
mechanism setting