Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
S-311
1-53
E - STANDARD MACHINE ADJUSTMENT
a) knives adjustment - LTT
a.1. Loosen the screw .
a.2. Turn the knife Ð in direction A and adjust the
position of the guide plate so that the lower edge
of the guide plate is aligned with knife edge ➐ .
a.3. Turn the knife Ð in direction A and adjust the
position of the fixing knife Ï to obtain no clearance
between them. Adjust the upper edge of the fixing
knife Ï to be aligned with knife Ð.
a.4. Align the upper and lower spring with fixing
knife Ï. (Spring boss faces towards the fixing
knife Ï.)
a.5. Tighten the screws .
a.6. Adjust the pin to protrude 1.8 — 2 mm on the
lower part of the knife Ð.
a.7. Loosen two screws .
a.8. Adjust the knife holder with fixing knife Ï in
direction D so that the fixing knife Ï touches the
knife Ð in distance 2—3 mm from the blade section
(pin is aligned with fixing knife face Ï). The
larger distance, the bigger pressure on the blade.
a.9. Tighten the screws
Blade section
Align to edge
Contact section
Blade face



B
A B

1,8 — 2 mm
14
18
20
17 16
15
16
15
20
14


A
2
—
3
m
m

D
22
14
25
20
26