Service manual

S-311
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
1-62
4.5. Remove the feet plate according to the part E2, point 2 and oil the bushing Ð and Ñ, rod of
the spreader Ò and Ó, stud and shafts , by one or two drops of oil to the marked places
on the drawing shown and on the machine are those places marked by red dors. To access to the
shafts, tilt the machine head after opening the rear cover and after turning the race by hand
according to the section E2 point 2,3.
4.6. Remove the side covers, unscrew the screws and
loosen the screws . Apply several drops of oil on the
side edges of the clamp feet closing levers and to the
marked lubrication holes .
4.7. After lubrication it is important to sew a minimum
10 buttonholes on scrap fabric to dispel any excess oil.
Wipe all visible excess oil from the mechanism in the
work area.
4.8. Reassemble all removed parts, fix the feet plates again.
4.9. To lubricate the adjustable cutting length steel, remove
the clamp plates and apply one drop of oil on the screw
and on the screw bearing.
F - MACHINE MAINTENANCE
8
10
11
9
8
7
12
13