Service manual

Revised 11/2006

E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

S-311+I

1-7 I

C - PROPER USAGE

2.3. Threading the machine S-311 CT+I

If you thread lower thread or gimp for the first time, it is necessary to dismantle the Indexer.

a) Loose screws and remove safety covers Ê.

b) Disconnect air pipes from cylinders.

c) Loose screws Ë of the right side feet holder and take it out.

d) Hold the device Ì and pull it to the left to take it out.

e) Remove the clamp plates Í and thread lower thread or gimp.

f) Mount the mechanism back into the machine.

Note: When assembling the right clamp foot, it is necessary to keep minimal distance of 0,5 mm.

See section E, chapter 1.

If the lower thread has just slipped out of the stitching plate, loose the screw Î and remove

the clamp feet cover Ï.