Service manual

S-4000 TKF, LS Omron
1-7
Revised 06/2010
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone]; Fax: [phone]
A - INTRODUCTION
CAUTION!
- Perform all regular service as described in this manual.
- If there is any problem with the power supply, turn off the main power switch.
- Do not remove, paint over, damage or in any way change safety labels. If a safety label cannot be
easily read, replace it.
- Long hair and loose clothing may be dangerous near any machinery. Always contain long hair
and avoid loose clothing, so that it cannot be caught by machinery and cause injury.
- Never use this machine while under the influence of drugs or alcohol.
- If anything seems to be operating incorrectly in the machine call for maintenance assistance
immediately.
- Be sure that there is adequate light for safe operation. A normal minimum light level is 750 lux.
7. SPECIAL ACCESSORIES
- machine device, which is not included in the standard equipment of the machine and can be ordered by
the customer
Light
- customer can order - no. 12.0008.4.403
- connection according to chart
(terminal connectors X0;cable clamps 3,4)
Warning: When turning on the light on the machine,
disconnect the machine from the power supply.
- in case, you do not want to interfere into the machine
wiring, it is possible to order the work light LBH-T65,
order no. 12.0008.4.875, which contains its own clip
fork the table and supply conductor with foprk (plug)
CEE7for connection to the power supply ~ 230 V.
Needles 750 SC 80/12, 70/10
- the manufacturer recommends to use these needles when sewing thin material
- part numbers 02.0750.2.100 (80/12), 02.0750.2.109 (70/10)