Service manual

S-4000 TKF, LS Omron
1-24
Released 12/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE CONTROLS
1. Max speed - maximal speed. Range 1000-3800 spm.
2. Slow stitch - selecting the number of stitches in slow start. Range 0-3.
3. Slow speed - setting the slow start speed at the beginning of the sewing cycle. Range 500-1000
spm.
4. Ndl Up pos - correction of the needle bar upper position. Range 0 - 600 imp.
5. D off delay - draw-off delay. It is possible to set it in range 60-150 ms.
6. D off tm - timing of the knife/draw-off activation. It is possible to set it in range 30-200 ms.
7. Trim delay - setting the trim delay. Ti is possible to set it in range 0 - 200 ms.
8. Trim time - setting the trim timing activation. It is possible to set in range 30 - 60 ms.
9. Clamp delay - setting the clamp delay. It is possible to set in range 0-100 ms.
10. Cycle delay - setting the delay between the sewing cycles. Cycling parameter must be activated.
It is possible to set it in range 500-2500 ms.
11. Cycling - setting the machine cycling. It is possible to set Yes / No.
12. Pedal - setting the foot pedal position. Possible setting 1 step / 2 steps.
13. Double Sew - setting the number of buttonhole repeat. It is possible to set 1, 2 = 1 or 2, 3 = 2.
14. L Count - life counter
15. Count Rst - counter restart
To return to the main screen, press key.