Service manual

S-4000 TKF, LS Omron
1-26
Released 12/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE CONTROLS
OUTPUTS
The following parameters can be tested only in case the air supply is connected to the machine. After
pressing key, appears on tehe display. To selected the line press key used for
change.
1. Clamps - Clamps off appears on the display. When the key is pressed, the clamp feets
are activated and clamps on apeears on display, to confirm the value press the
key and clamp feets are closed.
Lifting up the clamp feets:
press the key, to change the valve press the key and clamp off appears on
the display. To confirm the set values press the key and the clamp feets are
lifted up.
The valve YV2 is tested by this parameter.
2. D off - D off Off appears on the display. After pressing the key Off is blinking and by
pressing the key tension is activated and D off on appears on the display. To
confirm the set valve press this ke
y. The valve YV1 is tested by this parameter.
3. Trim - Trim off appears on the display. After pressing the
key the thread trim is
activated and trim on appears on the display, by pressing the button the set
value is confirmed. The valve YV3 is tested by this parameter.
To return in tests press the key, to finish the tests press the key.