Service manual

S-4000 TKF, LS Omron

1-44

Released 12/2009

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

E - MACHINE ADJUSTMENTS

17. THE HOLD DOWN ADJUSTMENT

(S4000 LS modification only)

1. It is necessary to adjust the hold down Ì by

loosening the screw Ê, if:

a) the hold down is not in the centre of

the clamp foot groove

b) the needle puncture Í is not in the

hold down groove or if the distance X

between the needle puncture and the

hold down groove is not the same on

both sides - see picture A

2. If a clearance exists between the hold down

and clamp foot, loosen the screw Ë and

move the hold down downwards. There

must not be any clearance between the hold

down and clamp foot.

Note: It is necessary to check the

adjustment mentioned in point 1 after this

adjustment.

Picture A