Service manual

1-26
S-104-100
Revised 09/2004
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
STOP MOTION ADJUSTMENTS
5. A clearance between brake pad L and right hand stop wheel B should be 0.25 mm (.010”). To adjust,
place the appropriate feeler gauge between the brake shoe and the right hand stop wheel. Pull rocking
lever all the way forward; holding it forward, turn the right hand stop wheel counterclockwise until it
locks.
6. Ensure all end play between three fork lever O and rocking lever N has been removed. This is done by
sliding the rocker lever shaft all the way to the casting. Move the three fork lever to the right, which will
remove all the end play. Re-tighten screw M. Remove the feeler gauge. Re-check clearance set in step 3,
re-set if necessary.