Installation Guide

AMIC Technology Corporation
Professional Installation Guide
Installation with FCC Approval
Electrical connection, commissioning, measurement, maintenance, and
calibration work on the unit is to be performed only by electrical specialists or
persons with equivalent training.
In countries or geographical regions where FCC approval is required, AMIC A9230-D
RFID reader may only be operated using the antennas listed in Table A.
Changes or modifications not expressly authorized by the relevant approval body may
result in revocation of the user’s operating permission.
A SMA female connector is provided on the reader for connecting the external antenna.
The maximum tightening torque for the SMA connector is 0.4 Nm. Higher tightening
torque can damage the connector and the reader)
Antenna Part Number
1 A9290-A-0C
2 A9290-A-0D
Table A: Antenna approved by FCC to be used with A9230-D RFID readers
01082007 Rev: 1.0
p1 of 1