User's Manual

AMIC A9280-B-000 User Guide
© AMIC Dec. 2004 – All rights reserved p 12 of 19 Rev 1.0
Write Block Data
Each RFID tag has user accessible memory blocks. Typically each memory block
contains 4 bytes of data for tags complying with ISO-15693 standard. Please refer
to RFID tag manufacturer’s data sheet for details. AMIC’s A9280-B-000 CF reader
will write 4 bytes of data per block to RFID tags at a time. Please follow the steps
below for Read Block Data.
1. Single click on the Block No. box and input the desired memory block number to
be written by the reader (default value is 0). The range of the block number
available for user access depends on the tag itself. Please refer to RFID tag
manufacturer’s data sheet for details.
2. Single click on the Block Data box and input the desired data to be written on to
the tag.
3. Hold the PDA as close as possible to the tag.
4. Single click on Write Data button to write the specified tag’s memory block.
5. The Operation OK / Fail Display box on the lower right hand corner should turn
green.
6. The data written to the tag should be displayed in the Response Information
box.
Figure – 9