Operation Manual
11
PRACTICAL WASHING HINTS
I. Cancelling and
changing the programme
To stop a washing programme, press the START push-
button and keep it depressed until the signal light READY
switches on.
When the washing machine is already operating, to change
the programme you must rst stop the one presently se-
lected by pressing the START pushbutton (see above) and
then you may select the desired programme.
NOTE! Changing the programme or temperature setting
and spin speed is possible only when READY signalling
light is shining. You cannot apply changes when WORK or
END lights are shining.
When during washing the selection knob shall be position
differently than operating programme, WORK signalling
light shall blink as long as the user puts it in a correct
position.
Any change of the position of the washing program selec-
tion knob without previous cancellation of current washing
program does not cause any change in the currently running
washing programme.
II. Power failure
If you pull out the mains plug or there is a power failure, the
current programme will not be cancelled. The programme
will be remembered and continued once the power supply
shall return to normal..
III. Load
IV. Delicate fabrics
Programme
Select a suitable washing programme (synthetic, silk,
wool, delicate fabrics).
Load
Refer to chapter III „Load”
Spin
The appliance automatically matches the maximum spin
rotation to a given programme.
Maximum drum capacity:
l6,0 kg for AWCM 10L type washing machine
Load clothes into the drum observing the following in-
structions:
lcotton - full drum (do not force clothes into the drum as
it may reduce the washing efciency!).
l synthetic - maximum 1/2 drum
l wool, silk, delicate fabrics - maximum 1/3 drum
Warning! Do not overload the appliance! Overloading may
cause damages to the washed clothes!