Operation Manual
14
VI. Door lock
The washing machine electronic PLC has been equipped
with the even load distribution control system. In case clo-
thes uneven load distribution in the drum has been detected
the washing machine shall automatically reduce spin speed
rotation or shall not consent to spin.
Uneven load can be caused by:
- excessive clothes quantity
- insufcient clothes quantity
- a single big piece of cloth that formed a sphere locking
other clothes.
VII. Even load
distribution control
Fabric softeners added for rinse:
• Observe the manufacturer recommendations.
• Pour softener into the middle chamber marked with
symbol.
• Do not exceed the MAX level marked on the drawer cham-
ber. The softener will be added in the last rinse.
Starch
• Observe the manufacturer recommendations.
• Starch using with „Cotton” programme: “Rinse”
• Pour starch into the middle chamber marked with
symbol.
Liquid washing agents
• Insert a partition into the main wash chamber marked
with symbol
• Fill the dose of the liquid washing agent recommended by
the manufacturer into the chamber.
VIII. Washing agents
and conditioners
The appliance is equipped with a door lock, which prevents
opening the appliance door during the washing process. In
case after interrupting the cycle or after nishing washing
you cannot open the door it means that the door lock is
still active.
To open the door wait for approximately 2 minutes.
NOTE! If a washing program has been stopped during the
washing process and there is a high temperature in the
washing drum, it can be that the appliance only unlocks the
appliance door, when the washing bath has been cooled
down to a temperature below 60 degrees Celsius.