Operation Manual

23
The oven can be warmed up using the bottom
and top heaters, as well as the grill. Operation
of the oven is controlled by the oven function
knob – to set a required function you should
turn the knob to the selected position, as well
as the temperature regulator knob – to set a
required function you should turn the knob to
the selected position.
OPERATION
The oven can be switched off by setting both
of these knobs to the position “”/“0”.
Natural convection oven
(conventional)
Oven functions and operation.
0 Oven is off
Independent oven lighting
Set the knob in this position to light up
the oven interior.
Top heater on
Setting the knob to this position allows
the oven to be heated only by the top
heater. Browning on top, finishing
baking, grilling.
Bottom heater on
When the knob is set to this position
the oven is heated using only the
bottom heater. Baking of cakes from
the bottom until done (moist cakes
withfruitstufng).
Top and bottom heaters on
Set the knob in this position for co-
nventional baking. This setting is ideal
for baking cakes, meat, sh, bread
and pizza (it is necessary to preheat
the oven and use a baking tray) on
one oven level.
Switching on the oven is indicated by two
signal lights, yellow and red, turning on. The
yellow light turned on means the oven is
working. If the red light goes out, it means the
oven has reached the set temperature. If a
recipe recommends placing dishes in a war-
med-up oven, this should be not done before
theredlightgoesoutforthersttime.When
baking, the red light will temporarily come
on and go out (to maintain the temperature
inside the oven). The yellow signal light may
also turn on at the knob position of “oven
chamber lighting”.
Roaster on.
Roasting is used for cooking of small
portions of meat: steaks, schnitzel,
fish, toasts, Frankfurter sausages,
(thickness of roasted dish should not
exceed2-3cmandshouldbeturned
over during roasting).