Operation Manual

Dear Customer
You are now a user of a kitchen extractor hood of OSC 6468W, OSC 5468W, OSC
6458I , OSC 5458I type. This hood has been designed and manufactured specially with
a view to satisfying your expectations and it will certainly constitute a fitting element of
a modern kitchen. The modern structural solutions and the newest technologies used in
production of this hood guarantee its high effectiveness and good appearance.
Please read these instructions carefully before installing the hood. They will help you
avoid mistakes during installation and operation of the hood.
We wish you a lot of satisfaction from choosing our kitchen extractor hood.
Amica
NOTE: The manufacturer will accept no responsibility for any damage due to installation or
operation not conforming to these instructions..
I Characteristics
OSC 6468W, OSC 5468W, OSC 6458I , OSC 5458I kitchen extractor hood was designed to
remove or neutralize kitchen fumes. It has to be installed permanently over a gas or electric
cooker. It requires installation of a conduit discharging used air to the outside if working in
fume removal mode. The conduit (a pipe Ø120 mm) shall not be longer than 4-5 m. The hood
can operate as an odour absorber after installation of an active carbon filter. In such case a
conduit discharging used air to the outside is not necessary. The kitchen hood is an electrical
appliance manufactured according to class II of fire protection, equipped with a permanent
supply cord and plug. It has its own lighting and an exhaust fan which can be set to one of
three rotational speeds.
II Technical data
Power supply voltage AC 230V 50 Hz
Fan motor 1
Lighting 40 W
Number of grease filters 1
Number of speeds 3
Width (cm) 50, 60
Depth (cm) 50
Height (cm) 13
Air outlet (ø mm) 120
Capacity (m
3
/h) 290
Power consumption (W) max. 115
Noise level (dBA) max. 50