Technical data

20
EMERGENCY PROCEDURES
Every time when emergency situation occurs you should:
• switch off the working assemblies of the plate
• disconnect power supply
• call in the service
• as some minor faults can be removed by the user in accordance with the below specified
instructions, before calling the Customer Service please go through the Table checking every
point.
3.The appliance does not
respond and emits a short
signal
- Children lock has been
activated
- Switch off the children lock
4.The appliance does not
respond and emits a long
signal
- Improper operation (improper
sensors have been touched or
proper sensors have been to-
uched for too short time
- Covered or dirty sensor (sen-
sors)
- Again activate the plate
- Uncover or clean the sensors
5.The whole appliance swit-
ches off
- No settings have been en-
tered within 10 seconds from
switching the plate on
- Covered or dirty sensor
(sensors)
- Again switch on the control
panel and immediately enter
the settings
- Uncover or clean the sen-
sors
6.One hotplate switches off
- Limited time of operation
- Covered or dirty sensor
(sensors)
- Again switch on the hot-
plate
- Uncover or clean the sen-
sors
PROBLEM
1.The appliance is not wor-
king
CAUSE
- Power supply failure
- Control panel has not been
switched on
- Sensors have been touched
for less than one second
- Several sensors have been
touched at the same time
ACTION
- Check the in-house fuse,
replace if necessary
- Switch it on
- Touch the sensors for a bit
longer
- Always touch only one sen-
sor (except when switching
off a hotplate)
2. The appliance does not
respond to entered settings