Operation Manual
76
EN
DOOR REVERSAL
6. Remove the two screws, which attach the lower hinge to the appliance door (Fig. 5). Take
special care and hold the appliance door with the other hand.
7. Holding the door, swing the lower door hinge away from the door using the other hand, then
detach the door from the appliance body (Fig. 6).
8. Remove the two screws , which attach the upper hinge to the body and the two screws hol-
ding the lower hinge to the appliance body (Fig. 7).
9. Screw the upper and lower hinge on the opposite side of the appliance body using suitable
screws (Fig. 8). Upper hinge should be mounted on the other side of the appliance as the lower
hinge. The lower hinge should be mounted on the other side of the appliance as the upper
hinge.
With the hinges open, hold the door parallel to the appliance body and screw the hinges to the
door using suitable screws while taking proper care.
10. Make sure that the door is properly aligned with the appliance body (Fig. 9).
INSTALLATION OF THE APPLIANCE
Installation of the appliance should be performed by a qualied installer. The appliance should be
placed in furniture case (Fig. 10). Once the appliance is placed correctly, adjust the height of the ap-
pliance by turning the 4 adjustable feet as appropriate. If necessary, adjacent Amica appliances sho-
uld be braced with a bracket xed by screws and tted in furniture (Fig. 11). There is a special strip
at the top of the appliance. Attach it to the underside of the cabinet with appropriate screws supplied
with the assembly kit (Fig. 16). Decorative strip must not block the vents located in the bottom casing
unit, the strip must be cut to size (Fig. 17). The depth of the bottom casing unit can be adjusted by
moving it forwards or backwards. Once properly adjusted, tighten the mounting screws (located in
the openings on both sides of the casing unit) with a cross-head screwdriver. This will permanently
attach the casing unit (Fig. 18).
FITTING FURNITURE BOARD TO APPLIANCE DOOR
Place the mounting bracket on furniture board and position it accordingly (Fig. 12). The distance between
the furniture board and the underside of the worktop should be 5 mm (Fig. 13). Attach the mounting
bracket using suitable screws supplied in the installation kit. Pull out the mounting bracket cover and
screw in the two special screws (2) in the appliance doors(Fig. 14). Attach furniture board with the xed
mounting bracket to the appliance door. Secure the furniture board with suitable nuts (item 3, Figure
14). Make sure the furniture board assembly is positioned correctly relative to the appliance (Fig. 15).
Using the supplied screws, attach the furniture board assembly to the bottom of the appliance door
(Fig. 15). Replace the mounting bracket cover in its original location.
1. Unplug the appliance before reversing the door opening direction.
2. Remove food from the appliance.
3. Remove caps on the front of the refrigerator body (Fig. 1, Fig 2).
4. Remove the two screws, which attach the upper hinge to the appliance door (Fig. 3). Take spe-
cial care and hold the appliance door vertically.
5. Holding the door, swing the upper door hinge away from the door using the other hand (Fig. 4).
Beespeciallycarefulduringthisstep,asthehingemaycloseandcauseinjury.