Specifications

About Your Product Warranty

AMICO welcomes warranty repair and apologizes to you for being inconvenienced. Any

Authorized Service Dealer may perform warranty repairs. Most warranty repairs are handled

routinely, but sometimes warranty service may be inappropriate. For example, warranty

would not apply if an engine is damaged because of misuse, lack of routine maintenance,

shipping, handling, warehousing and improper installation. Similarly, warranty is void if the

serial number on the engine has been removed or if the engine has been altered or

modified. If a customer differs with the decision of the Service Dealer, an investigation will

be made to determine whether the warranty applies. Ask the Service Dealer to submit all

supporting facts to his Distributor or the factory for review. If the distributor or the factory

decides that the claim is justified, the customer will be fully reimbursed for those items that

are defective. To avoid misunderstanding, which might occur between the customer and the

dealer, listed below are some of the causes of engine failure that the warranty does not

cover.

Normal wear:

Engines and generators, like all mechanical devices, need periodic parts service and replacement

to perform well. Warranty will not cover repair when normal use has exhausted the life of a part

of an engine.

Improper maintenance:

The life of an engine or your equipment depends upon the conditions under which it operates,

and the care it receives. Some applications, such as tillers, pumps, and rotary movers, are very

often used in dusty or dirty conditions, which can cause what appears to be premature, wear.

Such wear, when caused by dirt, dust, spark pug cleaning grit, or other abrasive material that

has entered the engine because of improper maintenance is is not covered by warranty.

This warrant covers engine related defective material and/or workmanship only, and not

replacement or refund of the equipment to which the engine may be mounted. Nor does

the warranty extend to repairs required because of:

1.ROBLEMS CAUSED BY PARTS THAT ARE NOT ORIGINAL OUR PARTS.

2.Equipment controls or installations that prevent starting, cause unsatisfactory. engine

performance manufacturer.

3.Leaking carburetors, clogged fuel pipes, sticking valves, or other damage, caused by using

contaminated or stale fuel. (Use clean, fresh*lead-free gasoline.)

4.Parts which are scored or broken because an engine was operated with insufficient or

contaminated lubricating oil, or an incorrect grated of lubricating oil (check oil level daily or

after every 8 hours of operation. Refill when necessary and change at recommended

intervals.) Engine damage may occur if oil level is not properly maintained. Read Operation

& Maintenance Instructions.

5.Repair or adjustment of associated parts or assemblies such as clutches, transmissions,

remote controls, ect., which are not manufactured by US

6.Damage or wear to parts caused by dirt, witch entered the engine because of improper air

cleaner maintenance, re-assembly, or use of a non-original air cleaner element or cartridge.

Read Operating &Maintenance Instructions.

7.Parts damaged by over-speeding, or overheating caused by grass, debris, or dirt, which plugs

or clogs the cooling fins, or flywheel area, or damage caused by operating the engine in a

confined area without sufficient ventilation.