User guide

www.amico.com 21
MRS Rail Cable Management
NOTE: A MRS cable guide is available to facilitate routing of cables along
the Rails and is not provided by default with the FIT Station.
1. Depending on where your CPU is mounted, guide the cables
from the FIT station going to the CPU into the side of the channel
leading to your CPU. (Figure 1)
2. Depending on where your electrical outlets are, guide the power
cables from the FIT station into the side of the channel leading to
your electrical outlets. (Figure 1)
3. Guide the MRS rail cable cover into the channel over the cable.
Ensuring no cable is pinched between the rail and the cover. Safely
trim o any excess MRS cover after installation.
(Figure 3)
Direction to slide
MRS Rail Cover
AHM Arm Cable Management
NOTE: FIT cable guide is provided to facilitate routing of cables along the bottom of the arm.
NOTE: Longer cable guides are provided for arms with extensions. Guides also snap into grooves on the bottom of
extension arms.
1. Ensure devices are mounted, ensure keyboard tray and swivel post cable management is complete. Take the
cables coming out of the keyboard tray and swivel post and press them between the openings of the cable
cover (Figure 1).
2. Ensure that there are at least 2” (5.08cm) of slack hanging free at the front end of the AHM Arm.
(Figure 1)
Cable Cover
Cable Guide
Cable
Guide
Edge
Bottom view of the
AHM Arm
(Figure 2)
AHM arm with cables
inserted
SECTION 3: Device Installation