User's Manual

User Manual v1.0.0

A: Force your NIC to 10Mbps or half duplex mode, and turn off the "Auto-negotiate"

feature of your NIC as a temporary measure. (Please look at the Network Control

Panel, in your Ethernet Adapter's Advanced Properties tab.)

4. Q: Why can't I connect to the Web Configuration?

A: you can remove the proxy server settings in your web browser.

7.9 BRC76N Setup

1. Q: Why does BRC76N ’s setup page shut down unexpectedly?

A: If one of the pages appears incompletely in BRC76N ’s setup pages, please click on

Logout item on the Main Menu before shutting it down. Don’t keep it working. Then,

close Internet browser and open it again for going back to the previous page.

2. Q: I don’t know how to configure DHCP.

A: DHCP is commonly used in the large local network. It allows you to manage and

distribute IP addresses from 2 to 254 throughout your local network via BRC76N .

Without DHCP, you would have to configure each computer separately. It’s very

troublesome. Please Open Internet browser > Input 192.168.1.1 in the website

blank field > Select DHCP Server under the IP Config Menu. For more information,

please refer to 3.3.2 (Router Mode) or 4.3.1 (AP Mode).

3. Q: How do I upgrade the firmware of BRC76N ?

A: Periodically, a new Flash Code is available for BRC76N on your product supplier’s

website. Ideally, you should update BRC76N ’s Flash Code using Firmware

Upgrade on the System Management menu of BRC76N Settings.

4. Q: Why is that I can ping to outside hosts, but cannot access Internet websites?

A: Check the DNS server settings on your PC. You should get the DNS servers settings

from your ISP. If your PC is running a DHCP client, remove any DNS IP address

setting. As the router assign the DNS settings to the DHCP-client-enabled PC.

5. Q: BRC76N couldn’t save the setting after click on Apply button?

A: BRC76N will start to run after the setting finished applying, but the setting isn’t written

into memory. Here we suggest if you want to make sure the setting would be written

into memory, please reboot the device via Reboot under System Management

directory.