Indoor Access Point: APH50C/ APH51C Quick Installation Guide APH50C Internal antenna
APH51C External antenna STEP 1. Package Content (1) Access Point : APH50C/ APH51C/ (2) Power Adapter (3) Wall Mounting screw set (4) Ceiling mounting bracket (9/16” and 15/16” flat T-bar included) (5) Dipole 2.
STEP 2.
STEP 3. Connecting the Device for Configuration (1) Connect one end of the Ethernet cable into the LAN1 port of the Access Point and the other end to the Ethernet port on the computer. (2) Plug in power source by different ways that depends on user setup environment (A) PoE Switch (Plug in from LAN1 Port) (B) PoE Injector (Plug in from LAN1 Port) (C) DC Power Adapter (Plug in from DC Jack) - Connect the Power Adapter to the DC-IN port of the Access Point and plug the other end into an electrical outlet.
STEP 5. Access Point Setup (1) Open a web browser on your computer. In the address bar of the web browser, enter 192.168.1.1 and enter. (2) A login screen will appear. The device do not have username and the password settings and can click login to access. (3) The access point user interface will appear. This device can operate in Access Point operating mode. User can start to complete the device set up.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Professional installation instruction 1. Installation personal This product is designed for specific application and needs to be installed by a qualified personal who has RF and related rule knowledge. The general user shall not attempt to install or change the setting. 2. Installation location The product shall be installed at a location where the radiating antenna can be kept 20cm from nearby person in normal operation condition to meet regulatory RF exposure requirement. 3.