Smart Mesh Router Quick Installation Guide STEP 0. Check the whole set: One Master and Satellites. STEP 1. Power on Mater, connects WAN port to Modem and LAN port to computer, respectively.
STEP 2. Powering on two satellites nearby Master synchronizes Master and Satellites. Synchronization is done as flash green for 5G LED, 2.4G LED, and solid green for Status LED in whole set.
LED Indicator Power/Status Internet (Single color) Wi-Fi/WPS WAN LAN Status Description ON Green System boot up ready and working normally Flashing Green (Interval : 1 sec) 1.System boot up progressing 2.Reset to default progressing (after push reset button 5 sec) Flashing Green (Interval : 0.5 sec) Mesh system pairing progressing (after push WPS button 1 sec) Flashing Green 30 sec (Interval : 0.
STEP 3. Setup Master as whole Mesh synchronized (1) In computer, open web browser, go to 192.168.1.254. Apply admin for both Username and Password. Click Sing in. (2) In QUICK SETUP Web (3.1) INTERNET CONNECTION TYPE: Fill in Username and Password of PPPoE provided by your ADSL agent. (3.2) WIRELESS SETUP: Give SSID, enable security, and give passwords. (3.
STEP 4. Satellites Placement and Configuration Move each Satellite to suitable location then power on for synchronization then enjoy the internet.
Easy Troubleshooting # Synchronization Fail: When these two conditions occur, synchronization is fail. 1. 5G, 2.4G LEDs are flash green, but status LED can’t show solid green. 2. In 192.168.1.254 web GUI, MESH SETUP, shows no or less than two satellites in Mesh Status List. Solution: To push WPS buttons of fail Satellite and Master at the same time. Then they will be forced synchronization.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
